Operation Manual – HWPing
H3C S3100 Series Ethernet Switches Chapter 1 HWPing Configuration
1-22
SD Maximal delay: 0 DS Maximal delay: 0
Packet lost in test: 0%
Disconnect operation number: 0 Operation timeout number: 0
System busy operation number: 0 Connection fail number: 0
Operation sequence errors: 0 Drop operation number: 0
Other operation errors: 0
[Sysname-hwping-administrator-icmp] display hwping history administrator
icmp
HWPing entry(admin administrator, tag icmp) history record:
Index Response Status LastRC Time
1 3 1 0 2000-04-02 20:55:12.3
2 4 1 0 2000-04-02 20:55:12.3
3 4 1 0 2000-04-02 20:55:12.2
4 3 1 0 2000-04-02 20:55:12.2
5 3 1 0 2000-04-02 20:55:12.2
For detailed output description, see the corresponding command manual.
1.3.2 DHCP Test
I. Network requirements
The HWPing client is an H3C S3100 series Ethernet switch, while the DHCP server can
be an H3C S5600 series Ethernet switch. Perform a HWPing DHCP test between the
two switches to test the time required for the HWPing client to obtain an IP address
from the DHCP server.
II. Network diagram
Figure 1-3 Network diagram for the DHCP test
III. Configuration procedure
z Configure DHCP Server(Switch B):
Configure DHCP server on Switch B. For specific configuration of DHCP server, refer to
the DHCP module in the H3C S5600 Series Ethernet Switches Operation Manual.
z Configure HWPing Client (Switch A):
# Enable the HWPing client.
<Sysname> system-view
[Sysname] hwping-agent enable
To Next Page
Loading...
Need help?
General