Operation Manual – CLI
H3C S3100 Series Ethernet Switches Chapter 1 CLI Configuration
1-7
# After configuring the switch, the general user switches back to user level 0.
<Sysname> super 0
User privilege level is 0, and only those commands can be used
whose level is equal or less than this.
Privilege note: 0-VISIT, 1-MONITOR, 2-SYSTEM, 3-MANAGE
2) HWTACACS authentication configuration example
# Configure a HWTACACS authentication scheme named acs, and specify the user
name and password used for user level switching on the HWTACACS server defined in
the scheme. Refer to AAA Operation for detailed configuration procedures.
# Enable HWTACACS authentication for VTY 0 user level switching.
<Sysname> system-view
[Sysname] user-interface vty 0
[Sysname-ui-vty0] super authentication-mode scheme
[Sysname-ui-vty0] quit
# Specify to adopt the HWTACACS authentication scheme named acs for user level
switching in the ISP domain named system.
[Sysname] domain system
[Sysname-isp-system] authentication super hwtacacs-scheme acs
# Switch to user level 3 (assuming that you log into the switch as a VTY 0 user by
Telnet).
<Sysname> super 3
Username: user@system
Password:
User privilege level is 3, and only those commands can be used
whose level is equal or less than this.
Privilege note: 0-VISIT, 1-MONITOR, 2-SYSTEM, 3-MANAGE
1.3 CLI Views
CLI views are designed for different configuration tasks. They are both correlated and
distinguishing. For example, once a user logs into a switch successfully, the user enters
user view, where the user can perform some simple operations such as checking the
operation status and statistics information of the switch. After executing the
system-view command, the user enters system view, where the user can go to other
views by entering corresponding commands.
Table 1-7 lists the CLI views provided by S3100 series Ethernet switches, operations
that can be performed in different CLI views and the commands used to enter specific
CLI views.
To Next Page
Loading...
Need help?
General