H3C S3100 8C SI User Manual

Operation Manual – CLI
H3C S3100 Series Ethernet Switches Chapter 1 CLI Configuration
1-8
Table 1-7 CLI views
View
Available
operation
Prompt
example
Enter method Quit method
User
view
Display
operation
status and
statistical
information of
the switch
<Sysname>
Enter user view once
logging into the
switch.
Execute the
quit
command to
log out of the
switch.
System
view
Configure
system
parameters
[Sysname]
Execute the
system-view
command in user
view.
Execute the
quit or
return
command to
return to user
view.
100 Mbps
Ethernet port
view:
[Sysname-Eth
ernet1/0/1]
Execute the interface
ethernet command in
system view.
Ethernet
port view
Configure
Ethernet port
parameters
1000 Mbps
Ethernet port
view:
[Sysname-Gig
abitEthernet1/
1/1]
Execute the interface
gigabitethernet
command in system
view.
Aux1/0/0
port (the
console
port)
view
The S3100
series do not
support
configuration
on port
Aux1/0/0
[Sysname-Au
x1/0/0]
Execute the interface
aux 1/0/0 command in
system view
VLAN
view
Configure
VLAN
parameters
[Sysname-vla
n1]
Execute the vlan
command in system
view.
VLAN
interface
view
Configure
VLAN
interface
parameters,
including the
management
VLAN
parameters
[Sysname-Vla
n-interface1]
Execute the interface
Vlan-interface
command in system
view.
Loopbac
k
interface
view
Configure
loopback
interface
parameters
[Sysname-Loo
pBack0]
Execute the interface
loopback command
in system view.
Execute the
quit
command to
return to
system view.
Execute the
return
command to
return to user
view.

H3C S3100 8C SI Specifications

General

Brand	H3C
Model	S3100 8C SI
Category	Switch
Language	English