H3C S3100 8C SI - Configuring a Hybrid-Port-Based Vlan

Operation Manual – VLAN
H3C S3100 Series Ethernet Switches Chapter 2 VLAN Configuration
2-4
To do… Use the command… Remarks
Enter VLAN view
vlan vlan-id
Required
If the specified VLAN does not exist,
this command be created first
creates the VLAN before entering its
view.
Add an Access port
to the current VLAN
port interface-list
Required
By default, system will add all ports
to VLAN 1.
Follow these steps to configure the Access-port-based VLAN in Ethernet port view:
To do… Use the command… Remarks
Enter system view
system-view
—
Enter Ethernet port view
interface interface-type
interface-number
—
Configure the port link
type as Access
port link-type access
Optional
The link type of a port is
Access by default.
Add the current Access
port to a specified VLAN
port access vlan vlan-id
Optional
By default, all Access
ports belong to VLAN 1.
 Note:
To add an Access port to a VLAN, make sure the VLAN already exists.
2.2.2 Configuring a Hybrid-Port-Based VLAN
A Hybrid port may belong to multiple VLANs, and this configuration can only be
performed in Ethernet port view.
Follow these steps to configure the Hybrid-port-based VLAN:
To do… Use the command… Remarks
Enter system view
system-view
—
Enter Ethernet port view
interface interface-type
interface-number
—
Configure the port link
type as Hybrid
port link-type hybrid
Required