H3C S3100 8C SI - Configuring a Mac Address Entry

Operation Manual – MAC Address Table Management
H3C S3100 Series Ethernet Switches
Chapter 1 MAC Address Table
Management
1-6
1.2.2 Configuring a MAC Address Entry
You can add, modify, or remove a MAC address entry, remove all MAC address entries
concerning a specific port, or remove specific type of MAC address entries (dynamic or
static MAC address entries).
You can add a MAC address entry in either system view or Ethernet port view.
I. Adding a MAC address entry in system view
Follow these steps to add a MAC address entry in system view:
To do… Use the command… Remarks
Enter system view
system-view
—
Add a MAC address entry
mac-address { static |
dynamic | blackhole }
mac-address interface
interface-type
interface-number vlan
vlan-id
Required
Caution:
z When you add a MAC address entry, the port specified by the interface argument
must belong to the VLAN specified by the vlan argument in the command.
Otherwise, the entry will not be added.
z If the VLAN specified by the vlan argument is a dynamic VLAN, after a static MAC
address is added, it will become a static VLAN.
II. Adding a MAC address entry in Ethernet port view
Follow these steps to add a MAC address entry in Ethernet port view:
To do… Use the command… Remarks
Enter system view
system-view
—
Enter Ethernet port view
interface interface-type
interface-number
—
Add a MAC address entry
mac-address { static |
dynamic | blackhole }
mac-address vlan vlan-id
Required