H3C S3100 8C SI - STP Maintenance Configuration; Introduction; Enabling Log;Trap Output for Ports of MSTP Instance; Configuration Example

Operation Manual – MSTP
H3C S3100 Series Ethernet Switches Chapter 1 MSTP Configuration
1-55
 Note:
z The VLAN-VPN tunnel function can be enabled on STP-enabled devices only.
z To enable the VLAN-VPN tunnel function, make sure the links between operator’s
networks are trunk links.
1.10 STP Maintenance Configuration
1.10.1 Introduction
In a large-scale network with MSTP enabled, there may be many MSTP instances, and
so the status of a port may change frequently. In this case, maintenance personnel may
expect that log/trap information is output to the log host when particular ports fail, so
that they can check the status changes of those ports through alarm information.
1.10.2 Enabling Log/Trap Output for Ports of MSTP Instance
Table 1-46 Enable log/trap output for ports of MSTP instance
Operation Command Description
Enter system view
system-view
—
Enable log/trap output for
the ports of a specified
instance
stp [ instance
instance-id ] portlog
Required
By default, log/trap output
is disabled for the ports of
all instances.
Enable log/trap output for
the ports of all instances
stp portlog all
Required
By default, log/trap output
is disabled for the ports of
all instances.
1.10.3 Configuration Example
# Enable log/trap output for the ports of instance 1.
<Sysname> system-view
[Sysname] stp instance 1 portlog
# Enable log/trap output for the ports of all instances.
<Sysname> system-view
[Sysname] stp portlog all