H3C S3100 8C SI User Manual

Operation Manual – 802.1x-System Guard
H3C S3100 Series Ethernet Switches Chapter 3 HABP Configuration
3-2
Operation Command Remarks
Configure the current
switch to be an HABP
server
habp server vlan
vlan-id
Required
By default, a switch operates
as an HABP client after you
enable HABP on the switch. If
you want to use the switch as
a management switch, you
need to configure the switch to
be an HABP server.
Configure the interval to
send HABP request
packets.
habp timer interval
Optional
The default interval for an
HABP server to send HABP
request packets is 20
seconds.
3.3 HABP Client Configuration
HABP clients reside on switches attached to HABP servers. After you enable HABP for
a switch, the switch operates as an HABP client by default. So you only need to enable
HABP on a switch to make it an HABP client.
Table 3-2 Configure an HABP client
Operation Command Remarks
Enter system view
system-view
—
Enable HABP
habp enable
Optional
HABP is enabled by default. And a
switch operates as an HABP client
after you enable HABP for it.
3.4 Displaying HABP
After performing the above configuration, you can display and verify your HABP-related
configuration by execute the display command in any view.
Table 3-3 Display HABP
Operation Command Remarks
Display HABP configuration and status
display habp
Display the MAC address table
maintained by HABP
display habp table
Display statistics on HABP packets
display habp traffic
These
commands can
be executed in
any view.

H3C S3100 8C SI Specifications

General

Brand	H3C
Model	S3100 8C SI
Category	Switch
Language	English