H3C S3100 8C SI User Manual

Operation Manual – SNMP-RMON
H3C S3100 Series Ethernet Switches Chapter 1 SNMP Configuration
1-6
Operation Command Description
Create or update the
view information
snmp-agent mib-view
{ included | excluded }
view-name oid-tree [ mask
mask-value ]
Optional
By default, the view name is
“ViewDefault” and OID is 1.
 Note:
An S3100 Ethernet switch provides the following functions to prevent attacks through
unused UDP ports.
z Executing the snmp-agent command or any of the commands used to configure
SNMP agent enables the SNMP agent, and at the same opens UDP port 161 used
by SNMP agents and the UDP port used by SNMP trap respectively.
z Executing the undo snmp-agent command disables the SNMP agent and closes
UDP ports used by SNMP agent and SNMP trap as well.
1.3 Configuring Trap Parameters
1.3.1 Configuring Basic Trap
Trap messages refer to those sent by managed devices to the NMS without request.
They are used to report some urgent and important events (for example, the rebooting
of managed devices).
Note that basic SNMP configuration is performed before you configure basic trap.
Table 1-4 Configure basic Trap
Operation Command Description
Enter system view
system-view
—
Enable the switch to
send Trap messages to
NMS
snmp-agent trap enable
[ configuration | flash | standard
[ authentication | coldstart |
linkdown | linkup | warmstart ]* |
system | ]
Enter port
view or
interface view
interface interface-type
interface-number
Enable
the port
to send
Trap
messag
es
Enable the
port or
interface to
send Trap
messages
enable snmp trap updown
Optional
By default, a
port is enabled
to send all
types of Traps.

H3C S3100 8C SI Specifications

General

Brand	H3C
Model	S3100 8C SI
Category	Switch
Language	English