Operation Manual – System Maintenance and Debugging
H3C S3100 Series Ethernet Switches
Chapter 1 Boot ROM and Host Software
Loading
1-12
Enter your choice(0-3):
Enter 2 in the above menu to download the host software using FTP.
The subsequent steps are the same as those for loading the Boot ROM, except for that
the system gives the prompt for host software loading instead of Boot ROM loading.
Caution:
When loading the Boot ROM and host software using FTP through BOOT menu, you
are recommended to use the PC directly connected to the device as FTP server to
promote upgrading reliability.
1.3 Remote Boot ROM and Software Loading
If your terminal is not directly connected to the switch, you can telnet to the switch, and
use FTP or TFTP to load the Boot ROM and host software remotely.
1.3.1 Remote Loading Using FTP
I. Loading Procedure Using FTP Client
1) Loading the Boot ROM
As shown in
Figure 1-8, a PC is used as both the configuration device and the FTP
server. You can telnet to the switch, and then execute the FTP commands to download
the Boot ROM program switch.btm from the remote FTP server (whose IP address is
10.1.1.1) to the switch.
Figure 1-8 Remote loading using FTP Client
Step 1: Download the program to the switch using FTP commands.
<Sysname> ftp 10.1.1.1
Trying ...
Press CTRL+K to abort
Connected.
220 WFTPD 2.0 service (by Texas Imperial Software) ready for new user
User(none):abc
331 Give me your password, please
To Next Page
Loading...
Need help?
General