Operation Manual – System Maintenance and Debugging
H3C S3100 Series Ethernet Switches
Chapter 1 Boot ROM and Host Software
Loading
1-13
Password:
230 Logged in successfully
[ftp] get switch.btm
[ftp] bye
Note:
When using different FTP server software on PC, different information will be output to
the switch.
Step 2: Update the Boot ROM program on the switch.
<Sysname> boot bootrom switch.btm
This will update BootRom file on unit 1. Continue? [Y/N] y
Upgrading BOOTROM, please wait...
Upgrade BOOTROM succeeded!
Step 3: Restart the switch.
<Sysname> reboot
Note:
Before restarting the switch, make sure you have saved all other configurations that
you want, so as to avoid losing configuration information.
2) Loading host software
Loading the host software is the same as loading the Boot ROM program, except that
the file to be downloaded is the host software file, and that you need to use the boot
boot-loader command to select the host software used for next startup of the switch.
After the above operations, the Boot ROM and host software loading is completed.
Pay attention to the following:
z The loading of Boot ROM and host software takes effect only after you restart the
switch with the reboot command.
z If the space of the Flash memory is not enough, you can delete the unused files in
the Flash memory before software downloading. For information about deleting
files, refer to the “File System Management” part of this manual.
z Ensure the power supply during software loading.
To Next Page
Loading...
Need help?
General