H3C S3100 8C SI User Manual

Operation Manual – Information Center
H3C S3100 Series Ethernet Switches Chapter 1 Information Center
1-13
 Note:
z When there are multiple Telnet users or dumb terminal users, they share some
configuration parameters including module filter, language and severity level
threshold. In this case, change to any such parameter made by one user will also be
reflected on all other user terminals.
z To view debugging information of specific modules, you need to set the information
type as debug when setting the system information output rules, and enable
debugging for corresponding modules through the debugging command.
II. Enabling system information display on a monitor terminal
After setting to output system information to a monitor terminal, you need to enable the
associated display function in order to display the output information on the monitor
terminal.
Table 1-11 Enable the display of system information on a monitor terminal
Operation Command Description
Enable the debugging/log/trap
information terminal display
function
terminal monitor
Optional
Enabled by default
Enable debugging information
terminal display function
terminal debugging
Optional
Disabled by default
Enable log information
terminal display function
terminal logging
Optional
Enabled by default
Enable trap information
terminal display function
terminal trapping
Optional
Enabled by default
 Note:
Make sure that the debugging/log/trap information terminal display function is enabled
(use the terminal monitor command) before you enable the corresponding terminal
display function by using the terminal debugging, terminal logging, or terminal
trapping command.

H3C S3100 8C SI Specifications

General

Brand	H3C
Model	S3100 8C SI
Category	Switch
Language	English