Operation Manual – System Maintenance and Debugging
H3C S3100 Series Ethernet Switches
Chapter 2 Basic System Configuration
and Debugging
2-3
Figure 2-1 The relationship between the protocol and screen debugging switch
 Note:
Displaying debugging information on the terminal is the most commonly used way to
output debugging information. You can also output debugging information to other
directions. For details, refer to Information Center Operation.
You can use the following commands to enable the two switches.
Table 2-3 Enable debugging and terminal display for a specific module
Operation Command Description
Enable system debugging
for specific module
debugging module-name
[ debugging-option ]
Required
Disabled for all modules
by default.
Enable terminal display
for debugging
terminal debugging
Required
Disabled by default.
Caution:
The output of debugging information affects the system operation. Disable all
debugging after you finish the system debugging.
To Next Page
Loading...
Need help?
General