Operation Manual – VLAN
H3C S3100 Series Ethernet Switches Chapter 2 VLAN Configuration
2-7
# Create VLAN 101, specify its descriptive string as “DMZ”, and add Ethernet1/0/1 to
VLAN 101.
<SwitchA> system-view
[SwitchA] vlan 101
[SwitchA-vlan101] description DMZ
[SwitchA-vlan101] port Ethernet 1/0/1
[SwitchA-vlan101] quit
# Create VLAN 201, and add Ethernet1/0/2 to VLAN 201.
[SwitchA] vlan 201
[SwitchA-vlan201] port Ethernet 1/0/2
[SwitchA-vlan201] quit
z Configure Switch B.
# Create VLAN 101, specify its descriptive string as “DMZ”, and add Ethernet1/0/11 to
VLAN 101.
<SwitchB> system-view
[SwitchB] vlan 101
[SwitchB-vlan101] description DMZ
[SwitchB-vlan101] port Ethernet 1/0/11
[SwitchB-vlan101] quit
# Create VLAN 201, and add Ethernet1/0/12 to VLAN 201.
[SwitchB] vlan 201
[SwitchB-vlan201] port Ethernet 1/0/12
[SwitchB-vlan201] quit
z Configure the link between Switch A and Switch B.
Because the link between Switch A and Switch B need to transmit data of both VLAN
101 and VLAN 102, you can configure the ports at the end of the link as trunk ports and
permit packets of the two VLANs to pass through.
# Configure Ethernet1/0/3 of Switch A.
[SwitchA] interface Ethernet 1/0/3
[SwitchA-Ethernet1/0/3] port link-type trunk
[SwitchA-Ethernet1/0/3] port trunk permit vlan 101
[SwitchA-Ethernet1/0/3] port trunk permit vlan 201
# Configure Ethernet1/0/10 of Switch B.
[SwitchB] interface Ethernet 1/0/10
[SwitchB-Ethernet1/0/10] port link-type trunk
[SwitchB-Ethernet1/0/10] port trunk permit vlan 101
[SwitchB-Ethernet1/0/10] port trunk permit vlan 201
To Next Page
Loading...
Need help?
General