Operation Manual – VLAN
H3C S3100 Series Ethernet Switches Chapter 2 VLAN Configuration
2-12
VLAN Type: Protocol-based VLAN
Protocol Index Protocol Type
0 ip
1 ethernetii etype 0x0806
VLAN ID: 200
VLAN Type: Protocol-based VLAN
Protocol Index Protocol Type
0 at
# Configure Ethernet 1/0/10 as a hybrid port, which removes the VLAN tag of the
packets of VLAN 100 and VLAN 200 before forwarding the packets.
[Switch-vlan100] quit
[Switch] interface Ethernet 1/0/10
[Switch-Ethernet1/0/10] port link-type hybrid
[Switch-Ethernet1/0/10] port hybrid vlan 100 200 untagged
# Associate Ethernet 1/0/10 with protocol template 0 and 1 of VLAN 100, and protocol
template 0 of VLAN 200.
[Switch-Ethernet1/0/10] port hybrid protocol-vlan vlan 100 0 to 1
[Switch-Ethernet1/0/10] port hybrid protocol-vlan vlan 200 0
# Display the associations between Ethernet 1/0/10 and the VLAN protocol templates
to verify your configuration.
[Switch-Ethernet1/0/10] display protocol-vlan interface Ethernet 1/0/10
Interface:Ethernet1/0/10
VLAN ID Protocol-Index Protocol-Type
100 0 ip
100 1 ethernetii etype 0x0806
200 0 at
The above output information indicates that Ethernet 1/0/10 has already been
associated with the corresponding protocol templates of VLAN 100 and VLAN 200.
Thus, packets from the IP and AppleTalk workstations can be automatically assigned to
VLAN 100 and VLAN 200 respectively for transmission by matching the corresponding
protocol templates, so as to realize the normal communication between workstations
and servers.
To Next Page
Loading...
Need help?
General