Operation Manual – Multicast
H3C S3100 Series Ethernet Switches Chapter 2 IGMP Snooping Configuration
2-16
Operation Command Remarks
Return to system view
quit
—
Enter VLAN interface view
interface Vlan-interface
vlan-id
—
Enable IGMP
igmp enable
Required
By default, the IGMP
feature is disabled.
Return to system view
quit
—
Enter Ethernet port view
for the Layer 2 switch to
be configured
interface interface-type
interface-number
—
Define the port as a trunk
or hybrid port
port link-type { trunk |
hybrid }
Required
port hybrid vlan vlan-id-list
{ tagged | untagged }
Specify the VLANs to be
allowed to pass the
Ethernet port
port trunk permit vlan
vlan-list
Required
The multicast VLAN
defined on the Layer
2 switch must be
included, and the
port must be
configured to forward
tagged packets for
the multicast VLAN if
the port type is
hybrid.
Table 2-19 Configure multicast VLAN on the Layer 2 switch
Operation Command Remarks
Enter system view
system-view
—
Enable IGMP Snooping
igmp-snooping enable
—
Enter VLAN view
vlan vlan-id
—
Enable IGMP Snooping
igmp-snooping enable
Required
Enable multicast VLAN
service-type multicast
Required
Return to system view
quit
—
Enter Ethernet port view
for the Layer 3 switch
interface interface-type
interface-number
—
Define the port as a trunk
or hybrid port
port link-type { trunk |
hybrid }
Required
To Next Page
Loading...
