H3C S3100 8C SI User Manual

Operation Manual – AAA
H3C S3100 Series Ethernet Switches Chapter 2 AAA Configuration
2-12
Table 2-10 RADIUS configuration tasks (the switch functions as a local RADIUS
server)
Task Remarks
Creating a RADIUS Scheme Required
Configuring RADIUS
Authentication/Authorization Servers
Required
Configuring RADIUS Accounting Servers Required
Configuring Shared Keys for RADIUS
Messages
Optional
Configuring the Maximum Number of
RADIUS Request Transmission Attempts
Optional
Configuring the Type of RADIUS Servers to
be Supported
Optional
Configuring the Status of RADIUS Servers Optional
Configuring the Attributes of Data to be Sent
to RADIUS Servers
Optional
Configuring the Local RADIUS
Authentication Server Function
Required
Configuring Timers for RADIUS Servers Optional
Configuring the
RADIUS server
Enabling Sending Trap Message when a
RADIUS Server Goes Down
Optional
Configuring the
RADIUS client
Refer to the configuration of the RADIUS
client
—
The RADIUS service configuration is performed on a RADIUS scheme basis. In an
actual network environment, you can either use a single RADIUS server or two
RADIUS servers (primary and secondary servers with the same configuration but
different IP addresses) in a RADIUS scheme. After creating a new RADIUS scheme,
you should configure the IP address and UDP port number of each RADIUS server you
want to use in this scheme. These RADIUS servers fall into two types:
authentication/authorization, and accounting. And for each type of server, you can
configure two servers in a RADIUS scheme: primary server and secondary server. A
RADIUS scheme has some parameters such as IP addresses of the primary and
secondary servers, shared keys, and types of the RADIUS servers.
In an actual network environment, you can configure the above parameters as required.
But you should configure at least one authentication/authorization server and one
accounting server, and you should keep the RADIUS server port settings on the switch
consistent with those on the RADIUS servers.

H3C S3100 8C SI Specifications

General

Brand	H3C
Model	S3100 8C SI
Category	Switch
Language	English