Operation Manual – DHCP
H3C S3100 Series Ethernet Switches Chapter 4 DHCP/BOOTP Client Configuration
4-3
II. Network diagram
Figure 4-1 A DHCP network
III. Configuration procedure
The following describes only the configuration on Switch A serving as a DHCP client.
# Configure VLAN-interface 1 to dynamically obtain an IP address by using DHCP.
<SwitchA> system-view
[SwitchA] interface Vlan-interface 1
[SwitchA-Vlan-interface1] ip address dhcp-alloc
4.5 Displaying DHCP/BOOTP Client Configuration
Table 4-2 Displaying DHCP/BOOTP Client
Operation Command Description
Display related information
on a DHCP client
display dhcp client [ verbose ]
Display related information
on a BOOTP client
display bootp client [ interface
Vlan-interface vlan-id ]
Optional
Available in any
view
To Next Page
Loading...
