H3C S3100 8C SI User Manual

Operation Manual – Login
H3C S3100 Series Ethernet Switches Chapter 2 Logging in through the Console Port
2-10
Operation Command Description
Configure to
authenticate users
using the local
password
authentication-mod
e password
Required
By default, users logging into a
switch through the Console port
are not authenticated; while
those logging in through
Modems or Telnet are
authenticated.
Set the local password
set authentication
password { cipher |
simple } password
Required
Set the
baud rate
speed speed-value
Optional
The default baud rate of an AUX
port (also the Console port) is
9,600 bps.
Set the
check
mode
parity { even | none |
odd }
Optional
By default, the check mode of a
Console port is set to none, that
is, no check bit.
Set the
stop bits
stopbits { 1 | 1.5 | 2 }
Optional
The default stop bits of a
Console port is 1.
Configure
the
Console
port
Set the
data bits
databits { 7 | 8 }
Optional
The default data bits of a
Console port is 8.
Configure the command
level available to users
logging into the user
interface
user privilege level
level
Optional
By default, commands of level 3
are available to users logging
into the AUX user interface.
Make terminal services
available to the user
interface
shell
Optional
By default, terminal services are
available in all user interfaces.
Set the maximum
number of lines the
screen can contain
screen-length
screen-length
Optional
By default, the screen can
contain up to 24 lines.
You can use the screen-length
0 command to disable the
function to display information in
pages.
Set history command
buffer size
history-command
max-size value
Optional
The default history command
buffer size is 10. That is, a
history command buffer can
store up to 10 commands by
default.

H3C S3100 8C SI Specifications

General

Brand	H3C
Model	S3100 8C SI
Category	Switch
Language	English