H3C S3100 8C SI User Manual

Operation Manual – Stack-Cluster
H3C S3100 Series Ethernet Switches Chapter 2 Cluste
r
2-20
Operation Command Description
Check the current
topology and save it as
the standard topology.
topology accept { all [ save-to
{ ftp-server | local-flash } ] |
mac-address mac-address |
member-id member-id |
administrator }
Required
Save the standard
topology to the Flash
memory of the
administrative device
topology save-to local-flash
Required
Restore the standard
topology from the Flash
memory of the
administrative device
topology restore-from
local-flash
Optional
Display the detailed
information about a single
device
display ntdp single-device
mac-address mac-address
Display the topology of
the current cluster
display cluster
current-topology
[ mac-address mac-address1
[ to-mac-address
mac-address2 ] | member-id
member-id1 [ to-member-id
member-id2 ] ]
Display the information
about the base topology
of the cluster
display cluster base-topology
[ mac-address mac-address |
member member-id ]
Display the information
about all the devices in
the base cluster topology
display cluster base-members
Optional
These commands
can be executed in
any view.
 Note:
When you display the cluster topology information, the devices attached to the switch
that is listed in the backlist will not be displayed.
IV. Configure cluster device blacklist
Follow these steps to configure the cluster device blacklist on a management device:

H3C S3100 8C SI Specifications

General

Brand	H3C
Model	S3100 8C SI
Category	Switch
Language	English