H3C S3100 8C SI User Manual

Operation Manual – HWPing
H3C S3100 Series Ethernet Switches Chapter 1 HWPing Configuration
1-29
III. Configuration procedure
z Configure HWPing Server (Switch B):
# Enable the HWPing server and configure the IP address and port to listen on.
<Sysname> system-view
[Sysname] hwping-server enable
[Sysname] hwping-server udpecho 10.2.2.2 9000
z Configure HWPing Client (Switch A):
# Enable the HWPing client.
<Sysname> system-view
[Sysname] hwping-agent enable
# Create a HWPing test group, setting the administrator name to "administrator" and
test tag to "Jitter".
[Sysname] hwping administrator Jitter
# Configure the test type as jitter
[Sysname-hwping-administrator-Jitter] test-type Jitter
# Configure the IP address of the HWPing server as 10.2.2.2.
[Sysname-hwping-administrator-Jitter] destination-ip 10.2.2.2
# Configure the destination port on the HWPing server.
[Sysname-hwping-administrator-Jitter] destination-port 9000
# Configure to make 10 probes per test.
[Sysname-hwping-administrator-http] count 10
# Set the probe timeout time to 30 seconds.
[Sysname-hwping-administrator-Jitter] timeout 30
# Start the test.
[Sysname-hwping-administrator-Jitter] test-enable
# Display test results
[Sysname-hwping-administrator-Jitter] display hwping results administrator
Jitter
HWPing entry(admin administrator, tag Jitter) test result:
Destination ip address:10.2.2.2
Send operation times: 100 Receive response times: 100
Min/Max/Average Round Trip Time: 9/21/13
Square-Sum of Round Trip Time: 18623
Last complete test time: 2000-4-2 8:14:58.2
Extend result:
SD Maximal delay: 10 DS Maximal delay: 10
Packet lost in test: 0%

H3C S3100 8C SI Specifications

General

Brand	H3C
Model	S3100 8C SI
Category	Switch
Language	English