Operation Manual – HWPing
H3C S3100 Series Ethernet Switches Chapter 1 HWPing Configuration
1-37
II. Network diagram
Figure 1-10 Network diagram for the DNS test
III. Configuration procedure
z Configure DNS Server:
Use Windows 2003 Server as the DNS server. For DNS server configuration, refer to
the related instruction on Windows 2003 Server configuration.
z Configure HWPing Client (Switch A)
# Enable the HWPing client.
<Sysname> system-view
[Sysname] hwping-agent enable
# Create a HWPing test group, setting the administrator name to "administrator" and
test tag to "dns".
[Sysname] hwping administrator dns
# Configure the test type as dns.
[Sysname-hwping-administrator-dns] test-type dns
# Configure the IP address of the DNS server as 10.2.2.2.
[Sysname-hwping-administrator-dns] dns-server 10.2.2.2
# Configure to resolve the domain name www.test.com.
[Sysname-hwping-administrator-dns] dns resolve-target www.test.com
# Configure to make 10 probes per test.
[Sysname-hwping-administrator-dns] count 10
# Set the probe timeout time to 5 seconds.
[Sysname-hwping-administrator-dns] timeout 5
# Start the test.
[Sysname-hwping-administrator-dns] test-enable
# Display test results.
[Sysname-hwping-administrator-dns] display hwping results administrator dns
HWPing entry(admin administrator, tag dns) test result:
Destination ip address:10.2.2.2
Send operation times: 10 Receive response times: 10
To Next Page
Loading...
