EasyManua.ls Logo

H3C S3100 8C SI - Page 896

H3C S3100 8C SI
944 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Operation Manual – IPv6 Management
H3C S3100 Series Ethernet Switches Chapter 1 IPv6 Configuration
1-11
z To enable a host to access a public IPv6 network, you need to assign an IPv6
global unicast address to it.
IPv6 site-local addresses and global unicast addresses can be configured in either of
the following ways:
z EUI-64 format: When the EUI-64 format is adopted to form IPv6 addresses, the
IPv6 address prefix of an interface is the configured prefix and the interface
identifier is derived from the link-layer address of the interface.
z Manual configuration: IPv6 site-local addresses or global unicast addresses are
configured manually.
IPv6 link-local addresses can be acquired in either of the following ways:
z Automatic generation: The device automatically generates a link-local address for
an interface according to the link-local address prefix (FE80::/64) and the
link-layer address of the interface.
z Manual assignment: IPv6 link-local addresses can be assigned manually.
Table 1-5 Configure an IPv6 unicast address
To do... Use the command... Remarks
Enter system view
system-view
Enter VLAN interface view
interface interface-type
interface-number
Manually
assign an IPv6
address
ipv6 address { ipv6-address
prefix-length |
ipv6-address/prefix-length }
Configure
an IPv6
global
unicast
address or
site-local
address
Adopt the
EUI-64 format
to form an
IPv6 address
ipv6 address
ipv6-address/prefix-length
eui-64
Use either command
By default, no
site-local address or
global unicast
address is
configured for an
interface.
Note that the prefix
specified by the
prefix-length
argument in an
EUI-64 address
cannot exceed 64
bits in length.
Automatically
generate a
link-local
address
ipv6 address auto
link-local
Configure
an IPv6
link-local
address
Manually
assign a
link-local
address for an
interface.
ipv6 address ipv6-address
link-local
Optional
By default, after an
IPv6 site-local
address or global
unicast address is
configured for an
interface, a link-local
address will be
generated
automatically.

Table of Contents

Related product manuals