HP ProCurve 7000dl Series User Manual

6-30
Configuring the Data Link Layer Protocol for E1, T1, and Serial Interfaces
Configuring the Logical Interface
Table 6-7. Default Settings for the DHCP Client
Before you enable the DHCP client, you must decide whether or not you want
to configure the settings listed in Table 6-7, and you must then include the
settings in the same command that you enter to enable the DHCP client. After
you enable the DHCP client, it immediately begins to search for a DHCP server
and negotiate a lease. You cannot impose settings on that lease after it is
established.
Accepting the Default Settings. If you want to use default DHCP settings
for the Frame Relay subinterface, you can simply enter:
ProCurve(config-fr 1.16)# ip address dhcp
The DHCP client on the Frame Relay subinterface will immediately begin to
send DHCP discovery message to find a DHCP server. When a DHCP server
responds, the client will negotiate an IP address.
The DHCP client will send DHCP discovery messages whether or not the
Frame Relay subinterface is activated or a valid connection has been estab-
lished. It will continue to send DHCP discovery messages until a DHCP server
responds.
Option Use Default Setting
client-id configures the client identifier displayed in the DHCP
server’s table
media type and interface’s MAC address
hostname configures the hostname displayed in the DHCP
server’s table
router hostname
no-default-route specifies that the DHCP client should not accept the
default route obtained through DHCP
accept default route from the DHCP
server
no-domain-name specifies that the DHCP client should not accept the
domain name included with the other lease settings
that the DHCP server sends
accept the domain name setting from the
DHCP server
no-nameservers specifies that the DHCP client should not accept the
DNS setting included with the other lease settings
that the DHCP server sends
accept DNS settings from the DHCP
server
track attaches a network monitoring track to the DHCP
client
(none)
<administrative
distance>
specifies the administrative distance to use when
adding the DHCP gateway into the route table
1

HP ProCurve 7000dl Series Specifications

General

Brand	HP
Model	ProCurve 7000dl Series
Category	Network Router
Language	English