© 2018 MA Lighting Technology GmbH - Dachdeckerstr. 16 - 97297 Waldbüttelbrunn - Germany
Phone +49 5251 688865-27 - support@ma-dot2.com - www.malighting.com
5.10. DMX key
The DMX key gives you access to different functions.
DMX View
Pressing the DMX key will open the DMX view on screen 1.
This is used to display your current DMX output.
DMX tester
The DMX command can be used to turn on specific DMX channels directly with out having to patch fixtures to
the DMX address - This is called DMX Tester. DMX channels that are controlling by the DMX Tester have a high
priority in the output. This means that it "locks" the channel while the DMX Tester have the control. You need to
release the DMX channel from the Tester before it acts normal again.
For example:
DMX 1 At 100
Will turn DMX channel at 100% = a DMX value of 255.
Off DMX 1
Will release the DMX channel from the DMX Tester.
Select a Fixture
It can also be used to select a fixture that uses a DMX channel.
For example:
DMX 2.40
Selects the fixture that uses DMX channel number 40 on the second DMX universe.
Direct patching
You can use the DMX key, and the DMX command, to patch fixtures.
For example:
Assign Fixture 5 at DMX 2.1
To Next Page
Loading...
