© 2018 MA Lighting Technology GmbH - Dachdeckerstr. 16 - 97297 Waldbüttelbrunn - Germany
Phone +49 5251 688865-27 - support@ma-dot2.com - www.malighting.com
7.20. Executor Command
This page describes the syntax and how to use the Executor command.
To go to the Executor command press Exec on the console.
Executor is in the command line now.
Executor
Description
With the Executor command you can, e.g.
select all fixtures stored on an executor
delete executors from the executor pool and the respective executor button on the console
delete cues from executors
set the intensity of an executor
trigger an executor
Syntax
1. Select all fixtures stored on an executor.
Executor 1
2. Delete an executor from the executor pool and the respective executor button on the console.
Delete Executor 1
3. Delete a cue from an executor.
Delete Cue 1 Executor 1
4. Set the intensity of an executor to 50 %.
Executor 1 At 50
5. Trigger an executor with a go.
Go Executor 1
To Next Page
Loading...
