© 2018 MA Lighting Technology GmbH - Dachdeckerstr. 16 - 97297 Waldbüttelbrunn - Germany
Phone +49 5251 688865-27 - support@ma-dot2.com - www.malighting.com
7.43. OutFade Command
This page describes the syntax and how to use the OutFade command.
To go to the OutFade command it is necessary to press another function key before, e.g. Store and press
Time twice (= OutFade).
Description
With the OutFade command, you can indicate out fade times
for a new cue with out fade time
in a existing cue
Indicate out fade times for getting smaller dimmer values.
Syntax
1. Store a new cue 1 with an out fade time of 4 seconds.
Store Cue 1 OutFade 4
2. Assign a out fade time of 5 seconds to the existing cue 3 on executor 1.
Assign OutFade 5 Cue 3 Executor 1
Example 1
Let´s assume, you will store a new cue on the main executor with an out fade time of 4 seconds.
Press Store 1 (= Cue 1) two times Time (= OutFade) 4 Please .
Cue 1 is stored with an out fade time of 4 seconds.
Double check the cue timing in the Cues View.
Example 2
Let´s assume, you will assign an out fade time of 5 seconds to the existing cue 3 stored on executor 1.
Press + Label (=Assign) two times Time (= OutFade) 5 Cue 3 Exec 1 Please .
Cue 3 on executor 1 has now an out fade time of 5 seconds.
Related Links
To Next Page
Loading...
