© 2018 MA Lighting Technology GmbH - Dachdeckerstr. 16 - 97297 Waldbüttelbrunn - Germany
Phone +49 5251 688865-27 - support@ma-dot2.com - www.malighting.com
7.33. IfOutput Command
This page describes the syntax and how to use the IfOutput command.
To go to the IfOutput command, press If (= IfOutput) on the console.
Description
With the IfOutput command you can select all fixtures in the fixtures view with a current
dimmer output above zero
dimmer output in a range
preset output
Syntax
1. Select all fixtures with a current dimmer output above zero.
IfOutput
2. Select all fixtures with the current dimmer output between 50 and 75.
IfOutput At 50 Thru 75
3. Select all fixtures with the current output of color preset cyan.
IfOutput Preset 4.2
Example 1
Let´s assume, you will select all fixtures with a current dimmer output above zero.
Press If (= IfOutput) Please .
All fixtures with a current dimmer output are selected in the fixtures view.
Example 2
Let´s assume, you will select all fixtures with a current dimmer output between 50 and 75.
Press If (= IfOutput) At 50 Thru 75 Please .
All fixtures with a current dimmer output between 50 and 75 are selected.
To Next Page
Loading...
