© 2018 MA Lighting Technology GmbH - Dachdeckerstr. 16 - 97297 Waldbüttelbrunn - Germany
Phone +49 5251 688865-27 - support@ma-dot2.com - www.malighting.com
7.69. Update Command
This page describes the syntax and how to use the update command.
To go the update command, press Update on the console.
Description
With the update command, you can update
groups
presets
cues
Syntax
Update
Example 1
Let´s assume, you edited a group 1 by using the edit command, and now you will apply the changes to group 1.
An indicator that the update function is available is the flashing Update key on the console.
Press Update Please .
The console asks, if you want to update Group 1. Tap Ok .
Group 1 is updated.
Example 2
Let´s assume, you edited preset 1 by using the edit command, and now you will apply the changes to preset 1.
Press Update Please .
The console asks, if you want to update Preset 1. Tap Ok .
Preset 1 is updated.
Example 3
Let´s assume, you have some values in the programmer and you will update preset 1 to these values.
There are two ways to do this:
a) Press Update and tap at preset 1 in the preset pools view.
To Next Page
Loading...
