© 2018 MA Lighting Technology GmbH - Dachdeckerstr. 16 - 97297 Waldbüttelbrunn - Germany
Phone +49 5251 688865-27 - support@ma-dot2.com - www.malighting.com
5.22. Flash key
The Flash key can be used to temporary use the flash function on one of the executors.
Pressing Flash followed by any of the keys associated with an executor will temporary keep the master level at
full as long as you keep the executor key pressed. If the executor was not active, then it will activate the first cue -
ignoring the cue timing. When you release the key, then the key will get its normal function again and the master
level is returned to it's previous position. If you didn't have an active cue on the executor when you flashed it, then
it will also make sure you don't have active cues when you release the flash.
Related link
Flash Command
What is Executors
To Next Page
Loading...
