© 2018 MA Lighting Technology GmbH - Dachdeckerstr. 16 - 97297 Waldbüttelbrunn - Germany
Phone +49 5251 688865-27 - support@ma-dot2.com - www.malighting.com
7.25. Full Command
This page describes the syntax and how to use the full command.
Important:
If you type the full command in the console, by press the Full key, the command will be directly
executed.
You can also use the command line along with the virtual keyboard and type the word full in.
To go to the full command, press Full on the console.
The full command will be directly executed.
Description
With the full command you set the intensity to 100 % of:
The selected fixtures
A selection of fixtures
An executor
Syntax
1. Set the intensity of the selected fixtures to 100 %.
Full
2. Set the intensity of a selection of fixtures to 100 %.
Fixture 1 Thru 3 Full
3. Set the intensity of an executor to 100 %.
Executor 1 Full
Example 1
Let´s assume you will set the intensity of the selected fixtures to 100 %.
Figure 1: Fixture at 0%
To Next Page
Loading...
