© 2018 MA Lighting Technology GmbH - Dachdeckerstr. 16 - 97297 Waldbüttelbrunn - Germany
Phone +49 5251 688865-27 - support@ma-dot2.com - www.malighting.com
7.16. Dmx Command
This page describes the syntax and how to use the Dmx command.
To go to the Dmx command, press DMX on the console.
Dmx is in the command line.
Description
With the Dmx command you can:
Make a DMX test.
Turn off the DMX tester.
Select a fixture on a DMX address.
Patch fixture to a DMX address.
Unpatch fixtures from a DMX address.
Syntax
1. Make a DMX test.
DMX 1.7 At 100
2. Turn off the DMX tester.
Off DMX Thru
3. Select a fixture on a DMX address.
DMX 2.2
4. Patch fixtures to a DMX address.
Assign Fixture 1 At DMX 2.1
5. Unpatch fixtures from a DMX address.
Delete DMX 1.7
To Next Page
Loading...
