© 2018 MA Lighting Technology GmbH - Dachdeckerstr. 16 - 97297 Waldbüttelbrunn - Germany
Phone +49 5251 688865-27 - support@ma-dot2.com - www.malighting.com
7.52. Release Command
This page describes the syntax and how to use the command Release.
To use this command, type Release into the command line.
Description
With the command Release it is possible to:
Enter release values for attributes in the programmer by a given object list. This list is filtered by the current
selection.
Important:
Release values that are stored with the option "Merge" release previously tracked values in the tracking
list and the fixtures use their default values.
Important:
-If you release an object, the command Release will be applied to the value layer.
-If you release an effect, the command Release will be applied to the effect layer.
Syntax
1. To enter release values for all attributes in the programmer within the selection of fixtures in the value
layer, type into the command line:
Release Selection
The letter R will be subsequently displayed in the value layer.
2. To enter release values for attributes of pan and tilt in the programmer within the selection of fixtures, type
into the command line:
Release PresetType "position"
3. To enter release values for an effect in the programmer, number 4 for instance, type into the command
line:
Release Effect 4
To Next Page
Loading...
