7.32. If Command
This page describes the syntax and how to use the if command.
To go to the if command, press and hold + If (= If) on the console.
Description
With the if command you can e.g.
deselect fixtures from the current selection if they are not in a group
limit the clone command and clones only if the fixtures is stored on an executor
limit the delete command and deletes only a fixture from a cue
select fixtures only if they are overlapping
Syntax
1. Deselect fixtures from the current selection if not stored in group 1.
If Group 1
2. Limit the clone command.
Clone Fixture 33 If Executor 1
3. Limit the delete command.
Delete Cue 3 If Fixture 1
Example 1
Let´s assume, you will deselect all current selected fixtures if they are not stored in group 1.
Press and hold + If (= If) Group 1 Please .
All fixtures which are not stored in group 1 are deselected.
Example 2
Let´s assume, you will clone the fixture 1 only on executor 2, because you need one more fixtures for the actors
light.
Press + Copy (= Clone) Fixture 1 At 33 Thru 35 + If (= If) and the respective executor
button Please .
The console will ask you to choose the clone method.
To Next Page
Loading...
