© 2018 MA Lighting Technology GmbH - Dachdeckerstr. 16 - 97297 Waldbüttelbrunn - Germany
Phone +49 5251 688865-27 - support@ma-dot2.com - www.malighting.com
7.65. Thru Command
This page describes the syntax and how to use the thru command.
To go to the Thru command, press Thru on the console.
Description
With the Thru command you can
select all fixtures in the fixtures view
select the range of fixtures in the fixtures view
delete cues and all following cues, from the main executor
delete cues and all following cues, from an executor button
Syntax
1. Select all fixtures in fixtures view.
Fixture Thru
2. Select the a range of a fixtures in the fixtures view.
Fixture 5 Thru 10
3. Delete cues and all following cues, from the main executor.
Delete Cue 3 Thru
4. Delete cues and all following cues, from an executor button.
Delete Cue 3 Thru Executor 2
The Thru command is a helping command and needs a second command or a number.
Example 1
Let´s assume you will select all the fixtures in the show.
To Next Page
Loading...
