© 2018 MA Lighting Technology GmbH - Dachdeckerstr. 16 - 97297 Waldbüttelbrunn - Germany
Phone +49 5251 688865-27 - support@ma-dot2.com - www.malighting.com
7.46. Pause Command
This page describes the syntax and how to use the pause command.
To go to the pause command, press the small Pause key on the console.
Description
With the pause command, you can
pause a crossfade between two cues
stop a current pause of an executor
The pause command is a toggle function.
If the executor is running, the pause command will set it to a pause.
If the executor is set to a pause, the pause command will stop the pause and keep him running again.
Syntax
To pause and stop a pause of an executor.
Pause Executor 1
Example 1
Let´s assume you will pause the chaser on executor 1.
Press the small Pause and then the respective executor button on the console.
The executor 1 is set to pause.
Example 2
Let´s assume you will stop the pause on executor 1 and keep the chaser running again.
Press the small Pause and then the respective executor button on the console.
The executor is running again.
Related Links
Pause Key
Executor Button [Go]
To Next Page
Loading...
