© 2018 MA Lighting Technology GmbH - Dachdeckerstr. 16 - 97297 Waldbüttelbrunn - Germany
Phone +49 5251 688865-27 - support@ma-dot2.com - www.malighting.com
7.51. Record Command
This page describes the syntax and how to use the Record command.
To use the Record command, type Record in the command line.
Description
With the Record command you can,
turn on
turn off
a timecode record for an executor.
Syntax
1. Turn on a timecode record.
Record On
2. Turn off a timecode record.
Record Off
Example
Let´s assume, you will start a timecode record for executor 6.
1. Open the command line window to use the virtual keyboard and type
Record On Executor 6
2. Press Please .
The timecode record starts and the flashing record icon is visible in the executor bar and the executor bar
window.
To Next Page
Loading...
