© 2018 MA Lighting Technology GmbH - Dachdeckerstr. 16 - 97297 Waldbüttelbrunn - Germany
Phone +49 5251 688865-27 - support@ma-dot2.com - www.malighting.com
7.56. Selection Command
This page describes the syntax and how to use the Selection command.
To go to the Selection command, press and hold and Fixture on the console.
Description
With the Selection command, you can deselect the current selection of fixtures.
The fixtures are removed from the programmer.
Syntax
Deselect the current selection of fixtures and remove them from the programmer.
Off Selection
Example
Let´s assume, you will deselect the current selection of fixtures and remove them from the programmer.
Figure 1: Selected fixtures in the programmer.
Figure 2: Deselected fixtures in the programmer.
Press Off + Fixture (= Selection) Please .
The current selection of fixtures is deselected.
To Next Page
Loading...
