7.54. Replace Command
This page describes the syntax and how to use the replace command.
To go to the replace command, press and hold and Move on the console.
Replace is in the command line.
If you press Move after a Replace is in the command line, the command will be With.
Description
With the replace command, you can replace
Presets with Presets
Fixtures with Fixtures
Groups with Groups
for an executor or in the show file.
Syntax
1. Replace a preset if it is used on a executor.
Replace Preset 1 With Preset 2 If Executor 1.2
2. Replace a fixture.
Replace Fixture 1 With Fixture 2
3. Replace a group.
Replace Group 1 With Group 2
Example 1
Let´s assume, you will replace position preset 4 "Singer" with position preset 5 "Piano" if it is used on executor 2.
1. Open the position presets pool.
2. Press + Move (=Replace), tap at preset 4 , press Move (=With), tap at preset 5 , press If and
executor button 2 Please .
Replace Preset 2.4 With Preset 2.5 If ExecButton 1.2
The console gives you an overview about how many objects will change and asks, to confirm the replace
operation.
To Next Page
Loading...
