© 2018 MA Lighting Technology GmbH - Dachdeckerstr. 16 - 97297 Waldbüttelbrunn - Germany
Phone +49 5251 688865-27 - support@ma-dot2.com - www.malighting.com
5.33. Highlt (Highlight) key
The Highlt (highlight) key is used to toggle the highlight mode.
When highlight is on, then all your
selected
fixtures will usually output a dimmer value of 100% and most fixtures
will turn open white without any gobos. The Highlight values are defined by the fixture profile and cannot be
changed in the console. They will stay like this as long as they are selected
and
highlight is on. You don't need to
gives your fixtures any value in the programmer. Highlight will temporary overwrite the outputting values, but not
put the dimmer, color and gobo in your programmer.
If you press and hold the Highlt key then your selected fixture will begin to flash as long as you keep the key
pressed.
This is a great feature if you try to locate a fixture in your rig.
To Next Page
Loading...
