© 2018 MA Lighting Technology GmbH - Dachdeckerstr. 16 - 97297 Waldbüttelbrunn - Germany
Phone +49 5251 688865-27 - support@ma-dot2.com - www.malighting.com
6.52. Position Preset Type View
To go to the Position Preset Type View, tap Position in the Preset Type Bar.
- or -
Press and hold and press 2 , for preset type 2 (= Position).
The position preset type view is only active if the selected fixture has a position attributes.
The position preset type view is fragmented in the position view and the raw position view.
To open the position effects view at screen 1, tap at in the title bar.
If an effect is running on a selected fixture, the position preset type view change into an effect mode and get a
blue effect mode title bar.
Position View
The position view is the first tab of the position preset type view.
In the position view, you control the actual position values in degrees.
Important:
The pan and tilt sliders works absolute. A tap on the pan or tilt slider sets a new pan or tilt value and
does not follow the already set pan or tilt values.
The respective encoders works relative to the already set pan or tilt values.
Pan Slider: To select the pan value, move the slider up or down.
Tilt Slider: To select the tilt value, move the slider up or down.
To Next Page
Loading...
