© 2018 MA Lighting Technology GmbH - Dachdeckerstr. 16 - 97297 Waldbüttelbrunn - Germany
Phone +49 5251 688865-27 - support@ma-dot2.com - www.malighting.com
7.45. Park Command
This page describes the syntax and how to use the Park command.
To go to the Park command, press and hold + Pause (=Park) on the console.
Park is in the command line.
Description
With the Park command, you can park
the current value of a fixture
a specific value of a fixture
the values of a preset type from a fixture selection
a specific DMX channel
Parked DMX channels are displayed with a blue background in the DMX view.
If you want to unpark DMX channels, open the tools window.
Syntax
1. Park the the current values of a fixture.
Park Fixture 1
2. Park all attributes of fixture 1 at 100 %.
Park Fixture 1 At 100
3. Park the values of the dimmer preset type of the current fixture selection.
Park PresetType Dimmer
4. Park a specific DMX channel.
Park DMX 1.1
Example 1
Let´s assume you will park the current values of fixture 1.
To Next Page
Loading...
