© 2018 MA Lighting Technology GmbH - Dachdeckerstr. 16 - 97297 Waldbüttelbrunn - Germany
Phone +49 5251 688865-27 - support@ma-dot2.com - www.malighting.com
7.60. Stomp Command
This page describes the syntax and how to use the Stomp command.
To go to the Stomp command press and hold + At (= Stomp) on the console.
Description
With the Stomp command, you mute running effects.
This is useful for pan tilt effects, because they are relative effects and a new pan tilt value does not mute the
current effect.
The stomp command is the same as the stomp in the effects view.
Syntax
Mute a running effect.
Stomp
Example
Let´s assume, you will mute all position preset type effects.
There are two ways to do this:
a) Open the position effects view and tap at Stomp .
b) Press + At (= Stomp) and tap at Position in the preset type bar.
All position effects are mute.
Related Links
MA Key
At Key
Effects View
To Next Page
Loading...
