© 2018 MA Lighting Technology GmbH - Dachdeckerstr. 16 - 97297 Waldbüttelbrunn - Germany
Phone +49 5251 688865-27 - support@ma-dot2.com - www.malighting.com
5.62. Time key
Pressing the Time key opens the Time defaults window.
Using this window you can set the different times used when storing new cues.
If you are storing a cue and you have pressed the Store key, then the Time key will flash when you have set a
different default timing than the factory defaults.
Also when you are storing cues, you can temporary store a different time than your defaults using the Time key.
When using Time with Store you get the Fade Command.
Example
You want to store cue 2 with a fade time of 3 seconds. You press:
Store Cue 2 Time 3 Please
Notice that the command line is actually changing the time command into fade:
Store Cue 2 Fade 3
If you continue to press the Time key during the store operation, you can get to all the different possible timings
in a cue (except the preset type timings).
Store Cue 1 Time 2 Time 3 Time 4 Time 5 Time 6 Time 7
Gives you this in the command line:
Store Cue 1 Fade 2 OutFade 3 Delay 4 OutDelay 5 SnapPercent 6 CmdDelay 7
Special Masters
You can use the Time key to create two different special masters.
To Next Page
Loading...
