© 2018 MA Lighting Technology GmbH - Dachdeckerstr. 16 - 97297 Waldbüttelbrunn - Germany
Phone +49 5251 688865-27 - support@ma-dot2.com - www.malighting.com
6.85.1.Wings & Nodes Diagnosis Window
To open the Wings & Nodes Diagnosis Window, press Tools and tap Wings & Nodes Diagnosis .
Figure 1: Wings & Nodes Diagnosis Window
The Wings & Nodes Diagnosis Window is useful if technical support is needed.
The Wings & Nodes Diagnosis displays the connection status of the console, wing, or Node4.
To select a type, tap in the table. The row of a selected type has a blue background.
The table has four columns:
Type:
Displays the type.
IP Address:
Displays the IPv6 address.
Status:
Displays the connections status e.g. connected, not connected or downloading firmware.
Connections:
Displays the amount of connections.
You can also identify every device in the network.
Select the device in the table, and tap at the frame icon in the title bar.
An orange frame starts to flash on the screen of the selected device.
To leave the Wing Setup Window, tap in the title bar or press Esc on the console.
To Next Page
Loading...
