7.29. Goto Command
This page describes the syntax and how to use the Goto command.
To go to the Goto command, press the Goto on the console.
Description
With the Goto command, you go to a specific cue on an executor
directly along with the cue timings
with fade time
Syntax
1. Go to cue 2 on executor 1.
Goto Cue 2 Executor 1
2. Go to cue 2 on executor 1 with a fade time of 5 seconds.
Goto Cue 2 Executor 1 Fade 5
Example 1
Let´s assume, you will directly execute cue 2 on the main executor.
Press Goto 2 (= Cue 2) Please .
Cue 2 from the main executor will be executed.
Example 2
Let´s assume, you will directly execute cue 2 on executor 1.
There are three ways to do this.
a) Press Goto 2 (= Cue 2) and then the respective executor button .
b) Press Goto 2 (= Cue 2) and tap on the respective executor in the executor bar view.
c) Press Goto 2 (= Cue 2) Exec 1 Please .
Cue 2 from executor 1 will be executed.
Example 3
Let´s assume, you will go to cue 2 on executor 1 with a fade time of 5 seconds.
To Next Page
Loading...
