© 2018 MA Lighting Technology GmbH - Dachdeckerstr. 16 - 97297 Waldbüttelbrunn - Germany
Phone +49 5251 688865-27 - support@ma-dot2.com - www.malighting.com
7.27. Go Command
This page describes the syntax and how to use the go command.
To go to the go command, press the small Go + on the console.
Description
With the go command you can e.g.
go to the next cue of a cue list
start running an executor
Syntax
1. Go to the next cue of a cue list.
Go
2. Start running an executor.
Go Executor 1
Example 1
Let´s assume, the executor 1 is running and you will go forward to the next cue on the cue list stored on executor
1.
There are two ways to do this.
a) Press the small Go + (= Go) and the respective executor button .
b) Press the small Go + (= Go) and tap on the respective executor in the executor bar view.
The next cue is running.
Example 2
Let´s assume, the executor 1 is off and you will start it running.
There are two ways to do this.
a) Press the small Go + (= Go) and the respective executor button .
b) Press the small Go + (= Go) and tap on the respective executor in the executor bar view.
The executor starts running with the first cue.
To Next Page
Loading...
