© 2018 MA Lighting Technology GmbH - Dachdeckerstr. 16 - 97297 Waldbüttelbrunn - Germany
Phone +49 5251 688865-27 - support@ma-dot2.com - www.malighting.com
7.68. Unpark Command
This page describes the syntax and how to use the unpark command.
To go to the unpark command, press and hold + small Go+ (=Unpark) at the console.
Unpark is in the command line.
Description
With the Unpark command, you unpark previous parked DMX channels
of a fixture
of preset type attributes from a fixture selection
Parked channels are displayed with a blue background in the DMX view.
To unpark all previous parked DMX channels, open the tools window.
Syntax
1. Unpark a previous parked fixture.
Unpark Fixture 1
2. Unpark a previous parked DMX channel.
Unpark Dmx 1.34
3. Unpark preset type attributes of the current fixture selection.
Unpark PresetType Dimmer
Example 1
Let´s assume you will unpark the previous parked fixture 1.
There are two ways to do this:
a) Press and hold + small Go+ (=Unpark) and tap at fixture 1 in the fixtures view.
b) Press and hold + small Go+ (=Unpark) Fixture 1 Please .
Fixture 1 is unparked.
To Next Page
Loading...
