© 2018 MA Lighting Technology GmbH - Dachdeckerstr. 16 - 97297 Waldbüttelbrunn - Germany
Phone +49 5251 688865-27 - support@ma-dot2.com - www.malighting.com
7.55. Select Command
This page describes the syntax and how to use the select command.
To go to the select command, press Select on the console.
Description
With the select command, you select fixtures
by DMX address
from a cue list stored on a executor
from a specific cue
The selected fixtures are displayed in the fixtures view.
Syntax
1. Select fixtures in the fixtures view by DMX address.
Select Dmx 1.1
2. Select all fixtures from a cue list stored on a executor.
Select ExecButton1 1.1
3. Select all fixtures in a specific cue.
Select Cue 1 ExecButton1 1.2
Example 1
Let´s assume, you will select the fixture using the DMX address 1.1.
Press Select and tap in the DMX view at 1.1 .
The fixture with the DMX address 1.1 is selected.
Example 2
Let´s assume, you will select all fixtures from the cue list, stored on executor 1.
There are three ways to do this:
a) Press Select and then press the respective executor button e.g. .
To Next Page
Loading...
