© 2018 MA Lighting Technology GmbH - Dachdeckerstr. 16 - 97297 Waldbüttelbrunn - Germany
Phone +49 5251 688865-27 - support@ma-dot2.com - www.malighting.com
7.57. SetIP Command
This page describes the syntax and the use of the SetIP command.
To use the SetIP command, type SetIP into the command line.
Description
Important:
Before using the SetIP command, save the show file. To save the show file, press Backup
Backup .Reboot the console after executing the SetIP command. This is very important for the console
to apply the new IP address.
Important:
The Art-Net IP address has to start with 2.x.x.x. or 10.x.x.x. .
With the SetIP command, you can:
Change the Art-Net IP address
Change the sACN IP / Web remote address
See the available Ethernet interfaces along with their IP address in the command line window.
After changing the IP address, reboot the console.
Syntax
1. Changes the Art-Net IP address.
SetIP eth0:1 2.2.3.5
2. Changes the sACN IP / Web remote address.
SetIP eth0 192.168.0.5
3. Displays the available Ethernet interfaces along with their IP address in the command line window.
SetIP
Example
Let´s assume you change the Art-Net IP address in your network.
1. To save the show file, press Backup Backup .
To Next Page
Loading...
