© 2018 MA Lighting Technology GmbH - Dachdeckerstr. 16 - 97297 Waldbüttelbrunn - Germany
Phone +49 5251 688865-27 - support@ma-dot2.com - www.malighting.com
7.50. Rate Command
This page describes the syntax and how to use the rate command.
To go to the rate command it is necessary to press another function key before, e.g. Store and then Speed .
Description
With the rate command you can store on an executor a:
Master Speed
Master Rate
For more information about what is a master speed or a master rate, refer to the glossary.
Syntax
Store a master speed or master rate on an executor.
Store Rate
Example
Let´s assume, you will store a master rate on executor 6.
There are four ways to do this:
a) Press Store Speed (= Rate) Exec 6 Please .
b) Press Store Speed (= Rate) and press the respective executor button .
c) Press Store Speed (= Rate) and tap on executor 6 in the executor bar view.
d) Tap on empty executor 6 in the executor bar view. The empty executor window opens. Tap
[Store]>[Speed]>[Executor] , then tap Master Rate .
To Next Page
Loading...
